Table of Contents
How do I Reset my Cisco access point password?
1. Press and hold the MODE button while you reconnect power to the AP. 2. Hold the MODE button until the Status LED turns amber (approximately one to two seconds), and release the button.
How do you Reset an access point?
Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle….
- Open the access point’s web-based setup page.
- Click the Administration tab and then click on the Factory Defaults sub-tab.
- Click Restore All Settings.
How do I Reset my Cisco router password without losing the configuration?
Reboot the router using the power switch. Press BREAK on the console terminal. When rommon>1 appears on the screen enter confreg 0x2142 comand to restart from the flash (This step skips the start-up configuration where the passwords are stored). Enter the RESET command when rommon2 > appears on the display.
How do I reset my Cisco AP 2702i?
Here is the procedure:
- Disconnect power from the AP or Disconnect the power jack for external power or the Ethernet cable for inline power.
- Press and hold the MODE button while you reconnect power to the AP.
- Hold the MODE button until the Status LED turns amber, and then release the button.
How do I find my cisco username and password?
The default username for your Cisco router is Cisco. The default password is Cisco. Enter the username & password, hit “Enter” and now you should see the control panel of your router.
How do I reset my cisco router to factory settings without a password?
Reset Router Using Reset Button
- With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
- Find the Reset button on the router.
- Press and hold the Reset button while you power on the router.
- Release the Reset button after 10 seconds.
How do I reset my Cisco access point wap321?
To restore the device to the factory default settings, with the power on, press-and-hold the Reset button with a bent paperclip for more than 10 seconds.
How do you reset a network switch?
The easiest way to reset the switch to its factory default settings is to look for its reset button located on the front panel, then press and hold for more than 10 seconds. You can also do it through the web interface of the switch.
How do I access Cisco WAP4410N?
Type 192.168. 1.245 (the default IP to access the admin interface) in the address bar of your internet browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your Cisco WAP4410N is admin.
What is the default IP for Cisco WAP4410N?
| IP Address | 192.168.1.245 Load Admin |
|---|---|
| Username | admin |
| Password | admin |
| SSID | ciscosb |
| Users Manual | User manual 2 of 2 |